Peugeot 308 Key Fob Problems and How to Fix Them
If your Peugeot 308 key fob stopped working one day, it could be due to a dead battery in the coin, water damage the receiver module or a malfunctioning electronic chip. Fortunately, these issues are easy to fix, and you'll have your vehicle back to normal in no time!
The key blade can become worn-out and cause a malfunctioning car key. It is easy to fix by visiting your local Car Key Man Auto Locksmith and let them put in the new blade for you.
Battery
The key fob on your Peugeot 308 may die or become weak enough to not send a strong signal. This could cause the key fob to stop working and prevent you from opening and locking the doors or even starting your engine. To fix this, you'll need to replace the battery on your key fob.
You'll need to purchase batteries for replacement from an auto parts store or at your local hardware store. Make sure the battery is brand new and has not on the shelf for too long. A brand new battery will have more capacity and will be able to send a more powerful signal to the car.
After replacing the battery, try unlocking the doors and locking them with the key fob. If the doors don't open it's likely that the receiver module in the car is the cause. The local Peugeot dealer can reprogramme the receiver module.
The internal chip of the key fob could also be damaged. It's possible to cause damage to your key fob if you drop it on the ground, or expose it to water. The rubber seals that protect your chip from moisture may be worn out over time. This is especially the case when you expose your key fob to water for extended periods of time, such as submerging it in the ocean. To avoid this you must keep your key fob away of the reach of moisture and away from water.
Water Damage
If your key fob gets soaked, whether you tossed it into the pool or threw it into a puddle, don't think it's a lost cause. While the key fob has rubber seals that should protect it from water, prolonged exposure to water may lead to damage to its electronic chip. Since water is a good conductor and conductor, any water that makes it inside the key fob will result in a series of short circuits, which could eventually ruin the chip. After removing the batteries, clean the contacts using isopropyl. Dry them completely before putting them back in.
Your Peugeot 308 may not start due to the battery being dead. If you have an extra vehicle, jumper cables can be used to get the engine going again. If the battery is the problem, it will need to be replaced.
A bad receiver in the car could also block it from receiving the signal from the keyfob. It could be due to a problem with the antenna or wiring, or the key fob could be damaged. If you're using an entirely new key fob, it might need to be programmed for the vehicle. If you're unable to fix the issue on your own, contact an expert technician. A trained technician will be able find the issue quickly and fix it promptly.
Radio Interference
Interference may cause symptoms like a key fob that is not recognized or has a narrow range. This can be either radiated, or conducted, with the former being caused by power supply cables or speaker wiring that is too close to electrical components. Generally, rerouting the cables or moving them further away from the components may solve the problem.
It's unlikely that someone is monitoring the key fob's signals to take your car away, but it's possible that your signal has been muffled by radio frequency interference. This is a simple problem to fix.
If you're having issues with your key fobs that aren't being recognized, try a fresh battery. Make sure that the battery is the right size and type. A wrongly sized battery can cause damage to the fob.
These devices may interfere with the key signal if they use the same radio frequency. It is best to avoid having these devices attached to your key fob.
Pairing G28 has an antenna that receives radio frequency signals from the key fob. It is not possible to start your car if this receiver isn't working, even if your key fob is functioning and can be reprogrammed. This problem can be caused by a variety different ways, such as the battery of the coin-cell being dead or water damage. The receiver may also be malfunctioning due to a software error or internal damage in the key.
The battery for your coin in your Peugeot 308 keyfob has probably been drained. It is easy to replace it with a new battery, but it is important to choose the right battery for your key fob. It is best to choose batteries that are the same size in terms of voltage, size, and specifications as the original.
Another reason the reason your Peugeot 308 key fob might not be working is because it is paired with a different car. You may have accidentally given the key fob to a friend or the key was used to unlock other vehicles. This can be resolved by reprogramming the key fob using an OBDII scan. This tool will request information about your car, like its VIN or engine type. It is essential to enter the correct details.